#include "itoa.h" #include // Setup for BW16 and ST7735 80 x 160 TFT #define USER_SETUP_ID 301 // See SetupX_Template.h for all options available #define ST7735_DRIVER #define TFT_WIDTH 80 #define TFT_HEIGHT 160 #define ST7735_GREENTAB160x80 // For ST7735, ST7789 and ILI9341 ONLY, define the colour order IF the blue and red are swapped on your display // Try ONE option at a time to find the correct colour order for your display // #define TFT_RGB_ORDER TFT_RGB // Colour order Red-Green-Blue // #define TFT_RGB_ORDER TFT_BGR // Colour order Blue-Green-Red // Pin Mappings for BW16 board #define TFT_MISO 11 #define TFT_MOSI 12 #define TFT_SCLK 10 #define TFT_CS 9 // Chip select control pin #define TFT_DC 8 // Data Command control pin #define TFT_RST 6 // Reset pin (could connect to RST pin) #define LOAD_GLCD // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH #define LOAD_FONT2 // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters #define LOAD_FONT4 // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters #define LOAD_FONT6 // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm #define LOAD_FONT7 // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:. #define LOAD_FONT8 // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-. //#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT #define LOAD_GFXFF // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts #define SMOOTH_FONT #define SPI_FREQUENCY 20000000 //#define SPI_FREQUENCY 27000000 // Actually sets it to 26.67MHz = 80/3